Plasma Cutting Tables for Metal Fabrication

sheet metal companies

572 Views

Although plasma cutting has been around since the 1970s and 1980s it was only recently that the technology has been greatly improved. Plasma cutters of the past were less precise, leaving marks and chips on metals and materials. They were not ideal for precision applications.

Plasma cutting technology has advanced significantly in recent years. Plasma cutting is widely used by many stores and companies around the world. It’s also one of the most efficient methods to reduce conductive metals like aluminum and stainless steel.

Here are some of the benefits and drawbacks of the plasma reducing table.

Pros

Plasma cutting has the lowest operating cost: Plasma cutting consumes less power than laser cutting. This means that a plasma cutter’s operating costs are somewhat lower than a comparable laser cutter.

Plasma cutting is the fastest manufacturing process: Plasma cutting can produce very fast results, especially when working with thicker materials. This can slow down laser cutters a bit.

Plasma cutting tables are capable of cutting very thick materials, which is a major advantage over laser cutters.

Cons

It is not ideal for precise cuts: A plasma jet used to cut products may not be as precise as a laser. However, this isn’t usually an issue unless you are working with very low tolerance applications.

Refinishing cuts may be necessary: Plasma cutters can produce dross and particles that adhere to the sides and bottom of a cut. Each cut might need to be refinished.

Only cut conductive metals. Plasma cutters must respond with a conductive material. This means that they are able to reduce conductive steel like steel and aluminum.

This article was written by Tyler Duoos, Tyler is that the owner of General Saw Company General Saw Company takes pride in being a leader in sheet metal fabrication services to Central Florida and its surrounding areas. If you are looking for sheet metal companies the work done right the primary time we tend to got you covered!

Leave a Reply